ZenPrimer 100 is a specialized primer for highly absorbent surfaces such as plaster or plasterboard (pladur). The product is extremely effective due to its deep penetration capabilities and is provided as a ready-to-use formula.
This is a water-based acrylic emulsion that only requires a single coat applied with a brush or a microfiber roller.
As a fast-drying adhesion promoter, it allows you to prepare surfaces for microcement application in just 30 minutes.
The product is manufactured to penetrate perfectly into absorbent surfaces; it is white in liquid form and becomes colorless once dry.
| Property | Details |
| Surface drying time (Touch dry) | 30 minutes |
| pH | 8 to 9 |
| Viscosity | 10 – 11 seconds (Ford Cup 4) |
| Solids content | 10.7% |
CONSUMPTION RATE
ZenPrimer 100: 0.10 L/m2
Before applying the primer, ensure the substrate is dry, clean, and free of grease, oil, and dust.
Wait between 30 minutes and 24 hours after applying the primer before proceeding with the first layer of microcement.
It is recommended to apply ZenPrimer 100 in a well-ventilated area with an ambient temperature between 5°C and 30°C.
It is advised to use rubber gloves and safety goggles to prevent direct splashes onto your person.
This is a safe primer, free of polluting components such as solvents or plasticizers.
To ensure maximum performance for future use, tightly close the container lid immediately after each use. This is the best way to prevent the primer from drying out or spoiling.
